We have two UTMs configured in High Availability mode. Thinks seem to be working OK for now. We're getting this pretty much continuously in our High-Availability log. 2016:03:10-00:00:05 perimeter1-2 ha_daemon[4301]: id="38A3" severity="debug" sys="System" sub="ha" seq="S: 394 05.320" name="Netlink: Found link beat on eth2 again!" 2016:03:10-00:00:05 perimeter1-2 ha_daemon[4301]: id="38A1" severity="warn" sys="System" sub="ha" seq="S: 395 05.320" name="All monitored interfaces with link again!" 2016:03:10-00:00:05 perimeter1-2 ha_daemon[4301]: id="38A0" severity="info" sys="System" sub="ha" seq="S: 396 05.320" name="state change UNLINKED(1) -> ACTIVE(0)" 2016:03:10-00:00:05 perimeter1-1 ha_daemon[4275]: id="38A0" severity="info" sys="System" sub="ha" seq="M: 968 05.880" name="Node 2 changed state: UNLINKED(1) -> ACTIVE(0)" 2016:03:10-00:00:06 perimeter1-2 ha_daemon[4301]: id="38A3" severity="debug" sys="System" sub="ha" seq="S: 397 06.442" name="Netlink: Lost link beat on eth2!" 2016:03:10-00:00:09 perimeter1-2 ha_daemon[4301]: id="38A1" severity="warn" sys="System" sub="ha" seq="S: 398 09.443" name="No link on interface eth2" 2016:03:10-00:00:09 perimeter1-2 ha_daemon[4301]: id="38A0" severity="info" sys="System" sub="ha" seq="S: 399 09.443" name="state change ACTIVE(0) -> UNLINKED(1)" 2016:03:10-00:00:09 perimeter1-1 ha_daemon[4275]: id="38A0" severity="info" sys="System" sub="ha" seq="M: 969 09.884" name="Node 2 changed state: ACTIVE(0) -> UNLINKED(1)" Does this imply a bad network cable, bad switch or something else?
↧