Yep. Both UTM's have: 1x WAN (em0) - PPPoE & vlan30 to Cisco switch which is connected to VDSL modem in bridge mode 1x LAN (em1) - multiple vlans here eg lan, dmz1, dmz 2 etc connected back to Cisco switch via port channeled trunk 1x HA link (em2) All are connected to the same vswitch on ESXi which allows all vlan tags through as the vlans are handled by the UTM. Basically, when I failover, I get one ping dropped between the lan and the dmz (as expected) but the wan drops for about 30 secs due to it being PPPoE with authentication. Also, as I set a preferred master as master, 5 minutes after the master is rebooted to test and the slave takes over, PPPoE drops again as the UTM reverts back to the preferred master.
↧