Hi Will, I finally figured out the needed configuration for clients to access the internet: In System > Routing > Static Routing Create new IPv4 Unicast Route with the following values: Destination IP / Prefix: 0.0.0.0 /0 (0.0.0.0) Gateway: Interface: Port 1.10 Distance: 0 For the IPTV, it will most likely not be possible to configure. In the KB, VLANs cannot be part of a bridge. Additionally, static interface cannot be defined without IP. Interfaces that are defined as part of a zone cannot configured without either IPv4 / IPv6 protocol. Thank you
↧
