Louis, You seem like a warrior, not giving up on this as yet? The same behavior this UTM offered under the bridge, WAN connection exist but no connection between the UTM and the Cisco 2960 switch. In any case I was driving myself too deep into it, and changed something. I guess I have to start all over again. One thing I observed on the LAN connection, unless the LAN has an IP from the same subnet under which the switch operates (10.10.11.0/24) UTM loses connection and also if the simple Ethernet is used it also loses connection. I guess I was at a stage where it started to ping the router from WAN like: UTM has 10.10.11.5/24 with DG set (this interface is VLAN 801 Ethernet. UTM has 10.10.12.4/24 with no DG set (this interface is VLAN 801) Ethernet? With Continuous disconnections on the internet and testing so many times the users are getting frustrated. I guess I leave testing till Monday. Will start fresh again.
↧