hi utmadm, Thank you for your time. I still can't get UTM to work. I posted a network Diagram with how I am trying to do this. I have turned off all firewall. I still can't understand why it doesn't work, I get no internet access on the end machine from the core switch. and Can't see any activity on the WAN. I'm very confused to how this program works. My understanding is with the Physical Firewall I have installed in the past. that you take the cable from the router/modem plug this in to the WAN and the LAN to the Switch. Not sure because this is a VM i'm messing this up but please do help i feel helpless. My Hardware Dell T110 II Power Edge Server with Three NIC''s Two are qlogic bcm5709c and 1 broad com. I have 32 gb ram and VM Workstation installed on this machine. The host os is W10 Pro. The VM's i have on here are UTM and Window Server 2012 R2. Vmware has three Virtual Networks Configured. VMXNET0, VMXNET1, VMXNET2. VMXNET0 is the WAN which is Bridged to the qlogic bcm5709c NIC 1 46. VMXNET1 is the LAN which is Bridged to the qlogic bcm5709c NIC 2 47. Where the UTM Internal is assigned. this is plugged in the core switch. VMXNET2 is the NIC for the Window SVR 2012 R2 which is coming from the core switch. I noticed when the Virgin Router is in Modem Mode UTM won't pick up any info under Ethernet DHCP. however my host machine is picking the information with the IP address. Like wise evan when i Put the Virgin Router in Router Mode with DHCP. It does than pick up an address but can't see any traffic on the WAN. And any device Connected to the Core switch won't get any internet.. My main issue is that i can't get WAN to work ! thought LAN show's activity . How do i do this setup! I have tried your instruction for( Change the network adapter drivers from "e1000" to "vmxnet3") . I have also setup the Masquerading rule, and firewall rule as per Sophos Instruction. Any one who uses VMworkstation and Virgin Router / Modem can they please advice on how I should setup this.
↧