Louis I got a different message on my email where you mention not to use the bridge on UTM? and start NAT function on the UTM? if that is correct I can remove the bridge and use WAN and LAN as separate ports with NAT enabled? ************************************************************************************************************************************************************************ The setup on the left hand side is fine as the Cisco is doing the natting/routing etc and the UTM is inline. On the right hand side, it's not the same. You need the UTM to mimic the Cisco router on the left hand side. So it needs to do Nat etc. I'd wipe your config and start from scratch for the UTM on the right hand side. Is a straight forward setup. ************************************************************************************************************************************************************************
↧